下面的內容是對于油嘴校驗器的事項闡述，所展示的高壓共軌試驗臺都是現場拍攝，提供的內容都是經過高壓共軌試驗臺廠家經驗所得，請點擊進入查看更多噴油泵試驗臺的相關行業信息吧。

油嘴校驗器的使用方法：

使用檢測儀前應檢查是否固定牢固，工作環境應清潔，檢測儀特別是裝夾噴油器的接頭處應擦拭干凈，然后加入沉淀48小時以上的0號輕柴油，嚴禁使用不合格的柴油。油嘴校驗器總成開啟壓力試驗，需要將三通放在支架中間，轉動支架上的螺桿，旋上高壓油管,將噴油器總成固定好，檢察安裝的密封性后，按動壓力桿進性泵油，并看壓力表。

Usage of nozzle calibrator:

Before using the detector, check whether it is firmly fixed, and the working environment should be clean. The detector, especially the joint where the injector is clamped, should be wiped clean, and then add 0 light diesel oil that has been precipitated for more than 48 hours. It is strictly forbidden to use unqualified diesel oil.

For the opening pressure test of the assembly of the nozzle calibrator, place the tee in the middle of the support, rotate the screw on the support, screw on the high-pressure oil pipe, fix the injector assembly, check the tightness of the installation, press the pressure rod to pump oil, and look at the pressure gauge.

英文由百度翻譯，僅供參考。